Found this problem
more than 3 times. when we disconnect the cisco ip phone from 4507 switch, and
then connect again, it cannot power on any more, when I connect to 4507 switch,
"show power inline" command displayed the port is " Ieee
PD" cannot displayed the IP Phone 7945... but when I move the cable to
Cisco Catalyst 3750, show power inline command, it dispalyed as IP Phone 7945.
We have the same
issue in three 4507 switch, no matter what I change the new cable or new IP
phone. doesn't work... I don't if the switch 4507 port have some problem or how
to reset the power inline to default. or you may have the same problem before
when you deployed the cisco IP phone to your network replace PBX phones.
The answer:
Here are some
4507 info:
System image file
is "bootflash:cat4500-ipbasek9-mz.122-53.SG1.bin"
cisco WS-C4507R-E
(MPC8540) processor (revision 13) with 524288K bytes of memory.
Processor board
ID
MPC8540 CPU at
800Mhz, Supervisor V-10GE
Last reset from
PowerUp
5 Virtual
Ethernet interfaces
248 Gigabit
Ethernet interfaces
4 Ten Gigabit
Ethernet interfaces
511K bytes of
non-volatile configuration memory.
1 48
10/100/1000BaseT (RJ45)V, Cisco/IEEE
WS-X4548-RJ45V+
2 48
10/100/1000BaseT (RJ45)V, Cisco/IEEE
WS-X4548-RJ45V+
3
6 Sup V-10GE 10GE (X2), 1000BaseX
(SFP) WS-X4516-10GE
4 6
Sup V-10GE 10GE (X2), 1000BaseX (SFP)
WS-X4516-10GE
5 48
10/100/1000BaseT (RJ45)V, Cisco/IEEE
WS-X4548-RJ45V+
6
48 10/100/1000BaseT (RJ45)V,
Cisco/IEEE WS-X4548-RJ45V+
7 48
10/100/1000BaseT (RJ45)V, Cisco/IEEE
WS-X4548-RJ45V+
Watts used of Chassis
Inline Power (-50V)
Inline Power Admin Inline Power Oper
Mod Model PS Device PS
Device Efficiency
---- ------------------- ---------------- ---------------- ----------
1 WS-X4548-RJ45V+ 222
208 74 69 94
2 WS-X4548-RJ45V+ 166
156 63 59 94
3 WS-X4516-10GE - -
- - -
4 WS-X4516-10GE - - - - -
5 WS-X4548-RJ45V+ 447
420 148 139 94
6 WS-X4548-RJ45V+ 396
372 130 122 94
7 WS-X4548-RJ45V+ 396
372 131 124 94
------------------------- ---------------- ---------------- ----------
Total 1627 1528
546 513
The issue at
Module 5, all this Module 5 cannot provide the PoE now... G5/* cannot provide the POE.
没有评论:
发表评论